See note below for a more detailed explanation. Receive Quality as measured by the percentage of packets (management and data frames) successfully received over the last 10 seconds. Wi-Fi adapters lower limit (aka receive sensitivity) is often around -80/-90. An average one is around -55, and a weak one starts around -70.
If all clients have PWR as -1 then it is likely that the driver doesn't support signal level reporting. Meaning you are hearing only 1/2 of the communication. If the PWR is -1 for a limited number of stations then this is for a packet which came from the AP to the client but the client transmissions are out of range for your Wi-Fi adapter. If PWR is -1 for some access points, it means the access point is out of range, however airodump-ng got at least a frame sent to it. If the BSSID PWR is -1, then the driver doesn't support signal level reporting. Its signification depends on the driver, but as you get closer to the AP or the station, the signal gets higher. Signal level reported by the Wi-Fi adapter. In this unassociated state, it is searching for an AP to connect with. In the Client section, a BSSID of “(not associated)” means that the client is not associated with any AP. In the example above the client rate of “36-24” means: In the example above, “WPA handshake: 00:14:6C:7E:40:80” indicates that a WPA/WPA2 handshake was successfully captured for the BSSID. The first line shows the current channel, elapsed running time, current date and optionally if a WPA/WPA2 handshake was detected. ivs format or merge them.Īirodump-ng will display a list of detected access points, and also a list of connected clients (“stations”). C : Uses these frequencies in MHz to hop band : Band on which airodump-ng should hop You can make it capture on other/specific channel(s) by using: essid-regex : Filter APs by ESSID using a regularīy default, airodump-ng hop on 2.4GHz channels. background : Override background detection. : Output file(s) write interval in seconds ignore-negative-one : Removes the message that says Pcap, ivs, csv, gps, kismet, netxml, logcsv uptime : Display AP Uptime from Beacon Timestamp manufacturer : Display manufacturer from IEEE OUI list berlin : Time before removing the AP/client
update : Display update delay in seconds beacons : Record all beacons in dump file It is possible, but not recommended, to run Kismet and airodump-ng at the same time.
Requirements: Windows 2000/XP/2003/Vista/7/8/10įREE EDITION DOWNLOAD PRO EDITION PURCHASEĭownload a free network analyzer to monitor, analyze and troubleshoot your network.Before running airodump-ng, you may start the airmon-ng script to list the detected wireless interfaces. The scanned results can be exported into. It will group all IP addresses according to MAC address if a MAC address is configured with multiple IP addresses. Colasoft MAC Scanner will display scan results in the list, including IP address, MAC address, Host Name and Manufacture.
How does it work?Ĭhoose a subnet from the Local Subnet combo box and click the Start button or F5 to execute scan.
FREE EDITION DOWNLOAD PRO EDITION PURCHASEĭownload a free network analyzer to monitor, analyze and troubleshoot your network. It can automatically detect all subnets according to the IP addresses configured on multiple NICs of a machine and scan the MAC addresses and IP addresses of defined subnets.
Colasoft MAC Scanner is used for scanning IP address and MAC address.